General

  • Corrected an issue in which leader lines were sometimes drawn incorrectly when you converted a drawing from an older format. (5660, 2026-04-10)
  • Addressed issue in which certain bent varying sets were not correct in the bend table. (11889, 2026-03-05) 
  • When you place multiple schedules, then recall one of them, the correct schedule now recalls; previously the "last edited" schedule would load rather than the selected one. (12068, 2026-02-24)
  • Linear and Linear Vary callout information is now handled properly when you copy the callout using the Modify Leader command or MicroStation Copy command. (11967/11942, 2026-02-11)
  • Circle callout information is now handled properly when you copy the callout using the Modify Leader or MicroStation Copy command. (11947/11944, 2026-02-11)
  • Radial callout information is now handled properly when you copy the callout using the Modify Leader or MicroStation Copy command. (11948/11945, 2026-02-11)
  • When you copy a vary set using the MicroStation Copy command, the EC (Engineering Content) data is now handled correctly. (11949, 2026-02-12)
  • Bar marks are now correct when the system builds the CAD database from EC (Engineering Content) data. (2026-02-11)
  • Addressed an issue that caused Linear, Radial, and Circumferential tools to lock up in certain circumstances. (11719, 2026-02-04)
  • Eliminated an issue in which ProStructures would crash when you attempted to launch the program in certain circumstances. (9094, 2026-01-28)
  • Addressed issue in which certain data was not handled properly if it contained non-English characters. (7969, 2025-10-23)
  • When you press Enter in Quantity to use Span and Spacing, you can now use Accudraw commands to set points to define the span/spacing values. (8601, 2025-11-
  • You can now place an xRef schedule, then place additional xRefs using normal placement, without issues. (8438, 2025-10-06)

Bar Input

  • You can now filter by Product Category without issues when selecting an end prep product. (9074, 2026-01-06)
  • Corrected an issue in which the system would erroneously assign a new bar mark containing an "M" (as in 10M, 15M) for certain metric drawings. (8436, 2025-10-06)

Copy Graphic

  • When you reference a drawing into a new drawing, then copy an xRef schedule from the original, the system now proceeds as expected. (8703, 2025-10-13)

Copy xRef

  • You can now perform the following series of actions without problems: a) Place an xRef and xRef schedule with callouts. b) Access a different drawing and reference the first drawing in. c) Select the xRef schedule and copy it into the active file using the aSa Copy Graphic tool. (8703, 2026-04-10)

Linear

  • You can copy a callout using MicroStation Copy, then edit and save the changes without issues. (11876, 2026-02-13) 
  • When you copy a Linear callout, then edit it in Bar Input, the original callout format now remains intact. (12336, 2026-02-13)
  • When you place a Linear Single run by Points > Auto, all bars now place properly. Previously, only the first bar was placed in certain circumstances. (5729, 2025-10-06)

Project Manager

  • License validations are now handled properly when you open Project Manager and multiple Studio modules at the same time. (9367, 2025-11-14)

Takeoff

  • Improved checks to prevent two control codes from the same job from having the same release number; previously, the issue could happen when the release contained an alpha character. (13552, 2026-03-26)
  • Orders generated from CAD takeoffs now use the correct job-level rounding rules. (13514, 2026-03-26)