Processing

Equipment Interface

When you enter an on-the-fly shape using Leg-Angle, hook directions are now handled correctly in BVBS machine instructions. (5208, 2025-06-11)
Progress MSR equipment can now be configured for use as cutter-benders OR as straighter machines. (4769, 2025-05-15)
aSa instructions can now be used to automate MEP LTM 300 and MEP Multisystem Bar 3D machinery. (4647, 2025-05-14)
Corrected an issue in which the system sent bars to a route that should have been restricted in certain circumstances. (4593, 2025-05-07)
Moved the Print Master Bundles at Collection Area field in the Machine editor to reflect changes made to the Schilt interface. (4611, 2025-05-08)
For certain Schilt equipment, we now have the ability to send instructions for a Head Cut - a cut that happens before running the bars on the table for shearing; a head cut is used to square all the bars to the same point in case the bars are not the same length. (1559, 2025-04-10)

Processing

When you assign material to a machine, the weight now updates immediately. Previously, the card did not update if the machine already had some material weight (unless you saved and reopened the session). (5722, 2025-06-26)
Corrected an issue in which the system was not using the specified unrestricted special bundling limits. (5399, 2025-06-17)
Cut lists are created and displayed correctly; previously, Optimization Objective information was causing issues in certain circumstances. (5303, 2025-06-16)
Weight scheduled per machine now displays properly, regardless of whether the machine has a capacity set up. (5108, 2025-06-05)

The MEP Multi-Radius is now treated (correctly) as as bender rather than as a coil (cutter-bender) machine. (4646, 2025-05-14)
Eliminated "Cannot read properties of undefined ..." error that occurred when you set up a cutter-bender type machine with length units that were not ft-in. (4765, 2025-05-20)
The Stock Lengths window, which shows stock and remnant lengths available for use, now includes a columns showing bars that are reserved on open cut lists. (301, 2025-04-10)
When you print a tags only run that includes a vary set, all the varying set tags are printed in sequence after the "regular" tags for each machine/bar diameter. (535, Base 25.1)

Reports & Inquiries

Shearing

Addressed issue in which the system developed master bundles that could not fit in the available bin space in certain circumstances. (2025-06-06)
Validations for maximum optimized length now considers whether or not the shear table moves. (4619, 2025-05-16)
Eliminated error that could occur when you changed the Optimization Target value in the Add Material window. (4669, 2025-05-12)
Corrected an issue in which certain logical cuts were not proposed by the system due to length rounding. (4025, 2025-04-07)
When multiple stock lengths are available, Shearing now considers more stock length combinations when calculating optimized cutting instructions. (575, Base 25.1)